CA 48530 Extra Assessment Task #1: Report

Your name: _______________________

This report is due by 4 pm Tuesday, November 5 to Jules Harnett.

1a.What value did you use for R₁? __________

1b.What was the largest amplitude you could obtain for the output, without distortion? _____________

1c.Include your hard copy showing input and output, in two plots on the same graph. Label the page “1c”.

2a.What value did you compute for R₅ using ideal op amp assumptions? _______________

2b.What was the output voltage with this value of R₅? _______________

2c.What [revised] value of R₅ resulted in an output of 10 volts? ________________

3a.What values for R and C did you use in your integrator, to get a good result?R = ________, C = __________

3b.Comment on the range of R and C which produced an integrating circuit which performed well.

3c. Include a Probe graph showing the input and output on the same graph.Label the graph “3c”.

4a.Provide a table of data showing frequencies (at least 8)and output amplitudes at those frequencies, and a Matlab graph of this data.Label the Matlab graph “4a.”

4b.What is your estimate of the cutoff frequency of this low pass filter, in Hz? __________________

If you did the extra credit portion, include a hard copy showing the input and output waveforms on the same graph.Label the hard copy “extra credit portion.”